Mitsubishi Pajero (2008-2017) NS, NT, NW & NX Spare Wheel Lift Kit

If you're installing a tow bar on your Pajero, then you'll need to raise the mounting points of the spare wheel located on the rear tailgate to allow for the extra height clearance some towing equipment needs.

Our wheel holder will raise the position of the spare wheel by 55mm, giving plenty of room to tow a boat or caravan without issue. Our spare wheel lift kits are made from high-quality steel and come in a black powder-coated finish.

What's included:
1x Wheel Holder (inc. wheel studs) to suit 2008-2017 Mitsubishi Pajero (NS, NT, NW & NX) Models
3x Mounting bolts

PLEASE NOTE: 
Wheel nuts are not included. The wheel holder uses the standard Pajero wheel nuts (12mm x 1.5). A minimum of three nuts are recommended.

The upper section of the standard wheel cover is removed when the accessory spare wheel lifter is fitted.

Fitting instructions are not supplied, however installation is very straight-forward. The only modification required is to trim the four screw bosses on the inside of the Spare Wheel Lower Cover by approx 10mm each.This is to allow the additional clearance required for the raised wheel.